8
4. Note: The parts in steps 7, 13, and 14 may
be preassembled. If the Press Arm Cable
(not shown) is preattached, make sure that it
g
oes over the Dip Arm (5) as this step is
completed.
Apply grease to an M10 x 115mm Bolt (84).
Attach the Dip Arm (5) to the Upright (3) with
the Bolt and an M10 Locknut (108). Make sure
that the Bolt is inserted through the indicat-
ed hole in the Dip Arm. Do not overtighten
the Locknut; the Dip Arm must pivot easily.
Attach the Dip Arm Pin (53) to the Dip Arm (5)
with an M4 x 13mm Self-tapping Screw (112).
Insert the Pin into the Dip Arm and the Upright
(3).
4
5
Hole
108
84
Grease
112
53
3
5. Attach the Weight Guide (13) to the Base (1)
with an M10 x 50mm Bolt (96), two M10
Washers (105), an 16mm x 6mm Spacer (11),
and an M10 Locknut (108).
Attach the Weight Guide With Hole (36) to
the Base (1) in the same manner. Make sure
that the indicated hole in the Weight Guide
is closer to the bottom.
Locate the fourteen Weights (27) that do not
have Weight Bushings (30) pressed into them.
Press two Weight Bushings into the outer holes
in each Weight. Make sure that all of the
Weights are oriented as shown, with the pin
holes on the bottom.
Slide two Weight Bumpers (29) onto the Weight
Guides (13, 36). Slide the fourteen Weights (27)
onto the Weight Guides.
Insert the Weight Tube (16) into the center hole
in the fifteenth Weight (27). Tap the Roll Pin
(79) into the top hole in the Weight Tube. Make
sure that the Roll Pin is underneath the
Weight and is centered in the Weight Tube.
Slide the Weight (27) onto the Weight Guides
(13, 36).
16
79
36
13
5
27
30
27
29
Hole
96
11
1
105
108
Pin
Hole
To Next Page
Loading...
