NordicTrack 360 - Page 9

9
6. See drawing 6b. Attach the Front Shroud (14)
t
o the Base (1) with an M4 x 16mm Self-tapping
Screw (99).
See drawing 6a. Note: If the Press Arm
Cable (not shown) has been routed through
the Top Cover (24), make sure that the Cable
c
rosses under the Top Frame (12) and
hangs between the Weight Guides (13, 36)
while this step is completed.
Attach the Top Frame (12) to the Weight Guides
(13, 36) with two M10 x 65mm Bolts (95), four
M10 Washers (105), two 16mm x 6mm Spacers
(11), and two M10 Locknuts (108). Do not
tighten the Locknuts yet.
Attach the Top Frame (12) to the Upright (3)
with two M10 x 100mm Button Bolts (91) and
an M10 Locknut (108).
Set the Top Cover (24) over the Front Shroud
(14) and the Top Frame (12).
See steps 3 and 6. Tighten the M10 Locknuts
(108) used in steps 3 and 6.
1
2
95
1
05
108
6a
6b
99
14
1
14
3
11
108
105
105
13
36
24
91
7. See the CABLE DIAGRAM on page 21 to
ensure correct cable routing during steps 7
through 14.
Use the wire in the Left Press Arm (7) to pull
the Press Arm Cable (66) up through the Press
Arm. Make sure that the Cable is routed
around the pulleys above the Press Arm as
shown in the inset drawing.
Hold a 4" Pulley (42) over the Press Arm Cable
(66). Attach the Pulley inside of the Swivel Arm
(26) with an M10 x 50mm Button Bolt (88), two
M10 Washers (105), two 16mm x 6mm Spacers
(11), and an M10 Locknut (108).
7
7
11
11
88
105
105
108
42
66
26
66