12
8
d
AC
A@
B\V&^8
6\
66
A^
[%a)L1+)*&
[1*%(
B
A\
C
d4& 5"#%+$&$'%&Q1+(1*%&Q12%"&?BD&)(&('1K+V&)+J&
(*#J%&#$&1+$1&$'%&Y/"#L'$&?A\D4
& Tip: Avoid pinching the Main Wire Harness
(25). >+(%"$&$'%&U#21$&;")0T%$&?66D&1+&$'%&
[)+J*%.)"&?CD&#+$1&$'%&Y/"#L'$&?A\D4&
& R$$)0'&$'%&U#21$&;")0T%$&?66D&K#$'&$K1&E8&a&
^8--&;1*$(&?ACD&)+J&$K1&E8&X10T+,$(&?6\D4&
Make sure that the Locknuts are in the hex-
agonal holes.
Tip: If necessary, rotate the Handlebar (4) to
a different angle so that there is sufficient
space to tighten the M8 x 58mm Bolts (24)
into the Upright (27).
84& 5"#%+$&$'%&G'#%*J&Q12%"&?A@D&)(&('1K+V&)+J&
/"%((&#$&1+$1&$'%&X%3$&)+J&P#L'$&G'#%*J(&?B\V&^8D4
Avoid pinching
the Main Wire
Harness (25)