13
12
77
15
14
49
49
84
12. While a second person holds the Console (15)
near the Handlebar (14), plug the Main Wire (77)
and the Pulse Wire (84) into the receptacles on
the Console.
The connectors on the Main Wire (77) and the
Pulse Wire (84) should slide easily into the
receptacles and snap into place. If a connector
does not slide easily into a receptacle, turn the
connector and try again. If you do not connect
the connectors properly, the Console (15) may
become damaged when you use the exercise
bike.
Insert the excess wire into the Handlebar (14).
Tip: Avoid pinching the wires. Attach the
Console (15) to the Handlebar (14) with four M4
x 16mm Screws (49). Start all the Screws, and
then tighten them.
Avoid pinching
the wires
13
13. Slide the Console Cover (16) upward against the
Handlebar (14). Attach the Console Cover with
two M4 x 16mm Screws (49).
14
49
16
To Next Page
Loading...
