18
20. Attach the TV assembly to the console assembly
with the four 5/16" x 3/4" Screws (1) that you
removed in step 19. Be careful not to pinch the
wires. Start all four Screws, and then tighten
them.
Attach the Lower TV Bracket Cover (135) with
four #8 x 3/4" Screws (5). Start all four Screws,
and then tighten them. Be careful not to over-
tighten the Screws.
20
135
1
Console
Assembly
TV
Assembly
5
5
21. Raise the Left Upright Cover (89), and connect
the coaxial cable from your wall (or device) to
the Upright Coaxial Cable (78).
Then, press the Left Upright Cover (89) and
the Right Upright Cover (not shown) onto the
Uprights (84) until they snap into place.
78
84
89
21
22. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the fl oor or carpet, place a mat under the treadmill. To
avoid damage to the console, keep the treadmill out of direct sunlight. Note: Extra parts may be included.
Keep the included hex keys in a secure place; one of the hex keys is used to adjust the walking belt (see
pages 42 and 43).
To Next Page
Loading...
