The console will begin scanning all TV channels. If
no broadcast signal is detected on a channel, the
c
hannel will be skipped; if a signal is detected, a
tone will sound and the channel will be stored in
m
emory. This process will continue until the high-
est channel is reached. The lowest channel stored
in memory will then appear in the main display.
Press the ENTER AGE/WT button again and
delete or add TV channels.
After all valid TV channels have been stored in the
console’s memory, you can delete unwanted
channels or add other channels. To delete or add
a channel, first press the CHANNEL + and – but-
tons until the channel appears in the main display.
Next, press the + or – button beside the ENTER
AGE/WT button until the words DELETE or ADD
a
ppear in the main display. Then, select the next
channel that you want to delete or add. Repeat
t
his process until you have finished deleting or
adding channels.
Hold down the ENTER AGE/WT button and the
RESET button simultaneously for two seconds
to exit the maintenance mode.
To exit the maintenance mode at any time, hold
down the ENTER AGE/WT button and the RESET
button simultaneously for two seconds.
15
14
25
To Next Page
Loading...
