NordicTrack A2050 NTL10850 - Page 8

SHdethetwoUprightCovers(75)ontotheendsofthe
PuUseBar(69),AHgnthehoUesintheUowerendsofthe
PuUseBarwiththehoUesintheUprightBase(85),
CutthetiesecuringthePuUseWire(74)totheUpright
Base(85),ConnectthePuUseWiretothePuUseBarWire
(79),TheconnectorsshouJdslidetogethereasiJyand
snapinto place.Iftheydonot,turnoneconnector
andtryagain.Insertthewiresdownintotherightsideof
theUprightBase(65),
HoUdthePuUseBar(69)againsttheUprightBase(85),Do
notdropthePuUseBarintotheUprightBase,Attachthe
PuUseBarto theUprightBasewiththefourPuUseBar
BoUts(66)andfourStarWashers(67),Becarefulnotto
pinchthewires.Startall four PulseBarBoltsbefore
tighteningthem.
SHdetheUprightCovers(75)overthePuUseBarBoUts
(66),
PressthetwoUprightCovers(75)ontotheUprightBase
(85),AttacheachUprightCoverwitha3/4"Screw(7),
66
79
74
66
--75
_7
.-- 85
--75
Cut the tie securing the Wires to the Upright Base (85),
Have a second person hold the console assembly near the
Upright Base (85), Connect the Upright Wire Harness (73)
and the Pulse Wire (74) to the wires extending from the
console assembly, The connectors shouJd shale together
easiJy and snap into pJace. If they do not, turn one con-
nector and try again. Insert the connectors into the
Console Assembly,
Connect the Upright Ground Wire (113) to the ground wire
extending from the console assembly, Make sure that the
wires are full inserted into each other, Insert the ground
wires into the Console Assembly,
7
Console
Assembl'
Ground
Wire
73