10
7. Attach the Frame Crossbar (107) to the Frame
(55) with two 1/4" x 1 3/4" Patch Bolts (91).
With the help of a second person, tip the tread-
m
ill so that the Base (94) is flat on the floor.
55
107
91
91
94
7
8. Set the console assembly face down on a soft
surface to avoid scratching the console.
Identify the Right Handrail (79). Hold the Right
Handrail near the console assembly. Route the
console wire through the large holes in the top
and bottom of the Right Handrail.
Set the Right Handrail (79) on the Console
Frame (81). Start a 1/4" x 1/2" Patch Bolt (8)
with a 1/4" Star Washer (12) into the Right
Handrail. Then, start two 5/16" x 1 1/2" Patch
Bolts (4) with two 5/16" Star Washers (9) into
the Right Handrail. Make sure that the console
wire is not pinched. Start all three Patch
Bolts, and then tighten each of them.
Attach the Left Handrail (not shown) as de-
scribed above. Note: There is not a wire on
the left side.
79
Console
Assembly
4
8
12
9
81
8
Console
Wire
To Next Page
Loading...
