NordicTrack A2550 PRO - Page 8

8
4. Insert a 3/8" x 5 1/2" Patch Bolt (7), a 3/8" x
3 3/4" Patch Bolt (97), and a 3/8" x 2 1/4" Patch
Bolt (31) with three 3/8" Star Washers (11) into
the Right Upright (83) in the locations shown.
Hold the Right Upright (83) against the Base
(94). Be careful not to pinch the Upright Wire
(85). Partially tighten the 3/8" x 5 1/2" Patch Bolt
(7) and the 3/8" x 3 3/4" Patch Bolt (97) until the
heads of the Patch Bolts touch the Right
Upright; do not fully tighten the Patch Bolts
yet. Then, partially tighten the 3/8" x 2 1/4"
Patch Bolt (31).
83
3. Identify the Right Upright (83), which is marked
with a “Right” sticker. Have a second person
hold the Right Upright near the Base (94).
See the inset drawing. Tie the wire tie in the
R
ight Upright (83) securely around the end of
the Upright Wire (85). Then, pull the other end
of the wire tie until the Upright Wire is routed
completely through the Right Upright.
94
Wire Tie
8
5
83
3
Wire
Tie
83
85
85
4
85
11
7
11
94
31
97