3. 3
Identify the Upright Cover (81). Orient the
Upright Cover as shown, and slide it upward
onto the Upright (4).
Have a second person hold the Upright (4) and
the Upright Cover (81) near the Frame (1).
Connect the Upper Wire (152) to the Lower Wire
(111).
,
Tip: Avoid pinching the wires. Slide the
Upright (4) onto the Frame (1).
Attach the Upright (4) with eight M10 x 20mm
Screws (91) and eight M10 Split Washers (105).
Do not tighten the Button Screws yet.
Slide the Upright Cover (81) downward. Do not
press the Upright Cover into the Left and
Right Front Shields (73, 74) yet.
105
9
73
Avoid pinching
the wires
105 91
105
7
To Next Page
Loading...
