.
Identify the Right Upper Body Arm (61) and the
Right Upper Body Leg (60), which are marked
with "Right" stickers, and orient them as shown.
Attach the Right Upper Body Arm (61) to the
Right Upper Body Leg (60) with three M8 x
43mm Button Bolts (96) and three M8 Jam Nuts
(102). Make sure that the Jam Nuts are in the
indicated hexagonal holes. Do not tighten the
Button Bolts yet.
Attach the Left Upper Body Arm (47) to the
Left Upper Body Leg (46) in the same way.
47
Holes
96
60
.
Using a plastic bag to keep your fingers clean,
apply some of the included grease to the Long
Axle (35) and to two 16mm Wave Washers (54)
(only one is shown).
Insert the Long Axle (35) through the Upright (4)
and center it.
Slide a 16mm Wave Washer (54) and the Right
Upper Body Arm (61) onto the right side of the
Long Axle (35).
Repeat these actions for the Left Upper Body
Arm (47).
Tighten an M8 x 23mm Button Screw (82) and
an M8 x 22mm Washer (97) into each end of the
Long Axle (35) at the same time.
82
4
35
Grease
54
97
8
To Next Page
Loading...
