PROBLEM: The walking belt slows when walked on
SOLUTION: a. Use onlya single-outlet surge suppressorthat meets all of the specifications described on page 8.
b. If the walking belt is overtightened,treadmill perfor-
mance may decrease and the walkingbelt may be-
comedamaged. Remove the key and UNPLUG THE
POWER CORD. Usingthe allen wrench, turn both
rear rolleradjustmentboltscounterclockwise,1/4 of a
turn. When the walking belt is properlytightened, you
shouldbe able tolift each sideof the walking belt 3 to
4 inchesoffthe walking platform.Be carefulto keep
the walking belt centered. Plug in the power cord, in-
sert the key and runthetreadmillfor a few minutes.
Repeat untilthe walking belt is properlytightened.
b
Rear RollerAdjustmentBolts
c. Ifthe walking belt still slowswhen walked on, please call our Customer Service Department, toll-
free.
PROBLEM: The walking belt is off-center or slips when walked on
SOLUTION: a. If the walkingbelt is off-center, removethe key and UN-
PLUG THE POWER CORD. If the walking belt has
shifted to the left, use the allen wrenchto turn the left
rear rollerboltclockwise1/2 ofa turn;if the walking belt
has shifted to the right, turnthe leftrear rollerboltcoun-
terclockwise1/2 of a turn. Be careful notto overtightenthe
walkingbelt. Plug inthe power cord,insertthe key and run
the treadmillfora few minutes.Repeat untilthe walking
belt iscentered.
a
b. If the walkingbelt slips when walked on,firstremove the
keyand UNPLUG THE POWER CORD. Usingthe allen
wrench, turnbothrear rollerboltsclockwise,1/4 of a turn.
When the walking beltis correctlytightened,you should
beable tolifteach side of the walkingbelt 3 to 4 inches off
the walkingplatform.Be careful to keep the walkingbelt
centered. Plug inthe power cord,insertthe key and care-
fullywalk on the treadmillfor a few minutes.Repeat until
the walkingbelt is properlytightened.
PROBLEM: The incline of the treadmill does not change correctly or does not change when iFIT.com
CDs and videos are played
SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re-
move the key. After a few seconds, re-insertthe key. The treadmillwillautomaticallyriseto the
maximum inclinelevel and then retumto the minimumlevel. Thiswillrecalibrate the incline.
24
To Next Page
Loading...
