NordicTrack C200 - Page 14

14
14. Attach the Pulse Crossbar (93) to the console
assembly with six #8 x 1/2" Screws (1). Start all
six Screws, and then tighten them.
Then, firmly tighten the four 5/16" x 3/4"
Screws (4).
14
93
Console
Assembly
4
4
1
1
1
15. Check the gaps between the handrail assem-
blies (B, C) and the console assembly.
If necessary, loosen the four #8 x 3/4" Screws
(2) under the handrails and slide the handrails
forward against the console assembly as indi-
cated by the arrows. Then, retighten the Screws.
Attach the Left Outside Upright Cover (87) and
the Right Outside Upright Cover (96) to the
Left and Right Uprights (89, 90) with two #8 x
3/4" Screws (2). Note: The top edge of each
Outside Upright Cover needs to be inserted
under the console assembly. Rotate each
Outside Upright Cover at an angle as you set
it against the Upright. Make sure not to over-
tighten the Screws.
15
89
90
2
2
87
2
B
C
Console
Assembly
96
2