5, Removetheknobfromthepin,Makesurethatthecollar
andthespringareonthepin,
PresstheLatchinsert(77)intotherightsideandthebft
Upright(85),andpresstheKnobinsert(92)intothebft
sideofthebft Upright,Usea rubbermallet,ifnecessary,
Next,insertthepinintotheLatchinsert,andtightenthe
knobbackontothepin,
KnobJ-_
77
ring
Collar
.@(_in
6, Makesurethatallpartsarepropertytightenedbeforeyou usethetreadmill.Keeptheincludedallen
wrenchinasecurepUace,Theallenwrenchis usedtoadjustthewaUkingbeUt(seepage26),Toprotectthe
flooror carpetfromdamage,placeamatunderthetreadmill.
if you purchase the optional chest puJse sensor (see page 22), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
1, Make sure that the power cord is unplugged. Remove
the indicated Screw (99) and the Access Door (95) from
the left side of the Console Back (98),
2, Connect the wire on the receiver (A) to the indicated wire
extending from the Console Back (98), Hotd the re-
ceiver so the small cylinder is oriented as shown and
is facing the Console Back. Attach the receiver to the
plastic posts on the Access Door (95) with the two in-
cluded small screws,
3, Make sure that no wires are pinched. Reattach the
Access Door (95) with the Screw (99), Discard the other
wires included with the receiver,
..... Wire
95_---@
// A/____ _ /
sma,,I1
o o
To Next Page
Loading...
