AttachthefourBasePads(81)tothebaseoftheUprights
(85)intheindicatedlocationswithfour 1"TekScrews
(82)andfourPlasticSpacers(101).Note:Onereplace-
mentBasePadmaybeincluded.UsetheBasePadtore-
placeanyBasePadthatbecomesworn.
Withthehelpofa secondperson,carefullytipthetread-
milldownsothefourBasePads(81)arerestingonthe
floorandtheUprights(85)areintheverticalposition.
55
101
101
101
82
85
101
....._ 82
.
Remove the band securing the Upright Wire Harness (73)
to the right Upright (85). Have a second person hold the
console assembly near the right Upright.
Connect the Upright Wire Harness (73) to the wires extend-
ing from the console assembly. Make sure to connect the
connectors properly (see the inset drawing). The con-
nectors should slide together easily and snap into
place. Ifthe connectors do not slide together easily and
snap into place, turn one connector and try again. IF THE
CONNECTORS ARE NOT CONNECTED PROPERLY,
THE CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON. Insert the connectors into the
right Upright (85).
3
Console
85
4. With the help of a second person, set the console assem-
bly on the Uprights (85). Make sure that no wires are
pinched. Attach the console assembly with four Console
Bolts (72) and four Star Washers (67) (only one side is
shown). Start all four Console Bolts before tightening
any of them.
4
67 \. co!so,e
! , 7Ass°bY
72 /I
7
To Next Page
Loading...
