If you purchase the optional chest pulse sensor (see page 24), follow the steps below to install the re-
ceiver included with the chest pulse sensor,
1. Make sure that the power cord is unplugged.
Remove the indicatedScrews (99) from the back
ofthe Console Base (98),
1 105
99 99 99 99 99
2. While a second person holds the Console (105),
connect the wire on the receiver (A) to the indi-
cated wire extending from the Console. Next,
hold the receiver so the small cylinder is ori-
ented as shown and is facing away from the
Console. Attach the receiverto the Console in
the locationshown withthe two includedSmall
Screws (B).
3, Make sure that no wires are pinched. See
drawing 1. Reattach the Console (105) to the
Console Base (98) withthe Screws (99). Discard
theother wires included withthe receiver.
Wire
10
To Next Page
Loading...
