HOW TO USE A CARDIO PROGRAM
D Insert the key into the console.
See HOW TO TURN ON THE POWER on page
13,
B Personalize console settings if desired.
See HOW TO PERSONALIZE CONSOLE SET-
TINGS on page 13.
1_1 Select a Cardio program.
To selectone of the ten Cardio program, press
the Programs button repeatedly.
CRRDIO .....w.E ... s,_D!
PRO_RRH i'"_ ..._.N,.
/
PRDGRRH TIHE ]fl:gD
i _.. L
When a Cardio program isselected, the display
willshow the name of the program, the program
time, the maximum incline setting of the program,
and the maximum speed setting of the program.
In addition, a profile of the speed settings of the
program will appear in the display.
Each preset program is divided into 30, 50, or 60
one-minute segments. One speed setting and one
incline setting are programmed for each segment.
Note: The same speed setting and/or incline set-
ting may be programmed for two or more consec-
utive segments.
B Press the Start button to start the program.
A moment afterthe button ispressed, the tread-
millwillautomatically adjustto the first speed and
inclinesettingsofthe program. Hold thehandrails
and begin walking.
l_'_ Select a display mode and monitor your
progress with the display and the training zone
bar,
When a Cardio program is selected, the console
offers three display modes. Press the Display but-
ton repeatedly to select the desired display mode.
If the first or second display mode is selected, a
profile of the speed settings of the programwillap-
pear inthedisplay.A small arrowbelowtheprofile
willindicate yourprogress.
At the end of the first one-minute segment of the
program, a series of tones willsound, if a different
speed setting and/or incline setting is pro-
grammed for the second segment, the speed set-
ting and/or incline setting will appear at the top of
the display for a moment to alert you. The tread-
mill will then automatically adjust to the speed and
incline settings for the second segment.
The program willcontinue in this way until the
small arrow reaches the rightend of the profile.
The walking belt will then slow to a stop.
If the third display mode is selected, the display
willshow an animationofa runner.
At the end of the first one-minute segment of the
program, a series of tones will sound. If a different
speed setting is programmed for the second seg-
ment, the speed setting will move along the bot-
tom of the displayto alert you. If a different incline
setting is programmed, the incline setting will ap-
pear at the top of the display for a moment. The
treadmill will then automatically adjust to the
speed and inclinesettingsfor the second seg-
ment.
The program will continue in this way until the last
segment ends. The walking belt will then slow to a
stop.
17
To Next Page
Loading...
