TROUBLESHOOTING
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and
follow the steps listed. If further assistance is needed, please see the front cover of this manual.
PROBLEM: The power does not turn on
SOLUTION: a. Make sure thatthe power cord is plugged intoa surge suppressor, and that the surge suppressor
isplugged into a properlygrounded outlet(see page 11). Use onlya single-outlet surgesuppres-
sor that meets all ofthe specificationsdescribedon page 11. Important:The treadmillis not com-
patiblewith GFCl-equipped outlets.
b. After the power cord has been plugged in, make sure that the key is insertedinto the console.
c. Check the reset/off circuit breaker located on the
treadmill frame near the power cord. If the switch pro-
trudes as shown, the circuit breaker has tripped. To
reset the circuit breaker, wait for five minutes and
then press the switch to the reset position.
PROBLEM: The power turns off during use
_ripped_
SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). Ifthe circuit breaker has tripped, wait
for five minutes and then pressthe switchto the reset position.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it,wait for five
minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key intothe console.
d. If the treadmill still willnot run, please see the front cover of this manual.
PROBLEM: The displays of the console do not function properly
SOLUTION: a. Remove the key from the console and UNPLUG THE
POWER CORD. Next, carefullylower the Uprights
(85). Remove the two indicated Belly Pan Screws
(32). Note: A phillipsscrewdriverwithan 8" shaft is
needed.
Raise the Upright (85) to the vertical position. Remove
the three 3/4" Screws (7) from the Hood (33), and
carefully pivot the Hood off.
27
To Next Page
Loading...
