Locate the Reed Switch (22) and the Magnet (18) on
the left side of the Pulley (17). Turn the Pulley until the
Magnet is aligned with the Reed Switch. Make sure
that the gap between the Magnet and the Reed
Switch is about 1/8". If necessary, move the Reed
Switchslightlyusinga slottedscrewdriver.Reattach
the Motor Hood (not shown), making sure that the 3/4"
Screws (not shown) are inserted intothe same holes
from which they were removed. Run the treadmill for a
few minutes to check for a correct speed reading.
Top
View
22_.
1/8'--
1-
PROBLEM: The walking belt slows when walked on
SOLUTION: a. Use onlya single-outlet surge suppressor that meets all of the specifications described on page 1t.
b. If the walkingbelt isovertightened, treadmill perfor-
mance may decrease and the walking belt may be-
come damaged. Remove the key and UNPLUG THE
POWER CORD. Using the hex key, turn both rear
roller bolts counterclockwise, 1/4 of a turn. When the
walking belt is properly tightened, you should be able
to lift each edge of the walking belt 3 to 4 inches off
the walking platform. Be careful to keep the walking
belt centered. Then, plug in the power cord, insert the
key, and run the treadmill for a few minutes. Repeat
until the walking belt is properly tightened.
Rear Roller Bolts
c. If thewalking belt still slows when walkedon, please see the front cover of this manual.
PROBLEM: The walking belt is off-center or slips when walked on
SOLUTION: a. Ifthe walking belt isoft-center, remove the key and
UNPLUG THE POWER CORD. If the walking belt
has shifted to the left, use the hex key to turn the
leftrear rollerbolt clockwise1/2 of a turn;if the walk-
ing belt has shifted to the right, turnthe leftrear
roller bolt counterclockwise1/2 of a turn. Be careful
notto overtightenthe walkingbelt. Plug inthe power
cord, insert the key, and runthe treadmillfor a few
minutes.Repeat untilthe walkingbelt is centered.
a
b. If the walking belt slips when walked on, first remove
the key and UNPLUG THE POWER CORD. Using
the hex key, turn both rear roller bolts clockwise, 1/4
of a turn. When the walking belt is correctly tightened,
you should be able to lift each edge of the walking
belt 3 to 4 inches off the walking platform. Be careful
to keep the walking belt centered. Then, plug in the
• power cord, insertthe key, and carefully walk on the
treadmill for a few minutes. Repeat until the walking
belt is properly tightened.
b
PROBLEM: The incline of the treadmill does not change correctly
SOLUTION: a. With the key inthe console, press one of the Incline buttons. While the incline is changing, re-
move the key. After a few seconds, re-insertthe key. The treadmill will automatically riseto the
maximum inclinelevel and then return to the minimum level. Thiswill recalibratethe inclinesys-
tem.
28
To Next Page
Loading...
