25
THE INFORMATION MODE
The console features an information mode that allows
you to view treadmill usage information and select a
system of measurement for the console. The informa-
tion mode also allows you to adjust the settings of the
television and to save channels into the television’s
memory.
Follow the steps below to use the information mode.
1. Hold down the Stop button while inserting the
key into the console.
When you select the information mode, the lower
part of the screen will show the total number of
hours that the treadmill has been used (Time) and
the total number of kilometers or miles that the
walking belt has moved (Distance).
In addition, the center of the display will show the
word “Metric” for metric kilometers or the word
“English” for English miles. Press the Speed in-
crease button to change the unit of measurement if
desired.
2. Press the Stop button and adjust the bright-
ness, contrast, color, sharpness, and/or hue of
the television.
When you press the Stop button, the brightness level
indicator will appear on the television screen. Press
the Volume buttons to adjust the brightness setting if
desired.
Next, press the Channel buttons until the contrast,
color, sharpness, or hue level indicator appears.
Adjust the settings, if desired, by pressing the
Volume buttons.
3. Press the Stop button again and add or delete
channels.
To add or delete a channel, first press the Channel
buttons until the desired channel number appears
on the screen. Then, press the Volume increase
button to add the channel, or the Volume decrease
button to delete the channel. Continue this process
until you have added all desired channels and
deleted all unwanted channels.
4. Press the Stop button again and select a signal
source.
In order to view channels, you must select the cor-
rect signal source. Press the channel increase but-
ton to select the PAL BG, PAL I, PAL DK, PAL DK
CHINA, SECAM L, or SECAM LL source; try all six
sources, if necessary, to find the optimal source.
Note: If you are in France, first try one of the
SECAM sources. If you are in the United Kingdom,
first try the PAL I source. If you are in any other
country, first try the PAL BG source. If the picture
from the first signal source is not clear, try the
other five sources.
5. When you are finished using the information
mode, remove the key.
To exit the information mode at any time, remove
the key from the console.
To Next Page
Loading...
