12
6
81
90
89
86
E
86
28
11
11
28
9
9
28
28
5
5
81
93
A
7
7. IMPORTANT: To avoid damaging the Pulse
Crossbar (93), do not use power tools and do
not overtighten the #10 x 3/4" Screws (9).
Orient the Pulse Crossbar (93) as shown. Attach
the Pulse Crossbar to the Handrails (86) with two
#10 x 3/4" Screws (9) and two #10 Star Washers
(5); start all four Screws, and then tighten
them.
Next, firmly tighten the four 5/16" x 2 1/2"
Screws (28).
Then, remove the wire tie (A) from the Upright
Wire (81).
6. Attach a Handrail (86) to the Right Upright (90)
with two 5/16" x 2 1/2" Screws (28) and two
5/16" Star Washers (11) in the location shown;
do not fully tighten the Screws yet. Make
sure not to pinch the Upright Wire (81), and
make sure that the wire is on the side of the
Upright as shown.
Attach the other Handrail (86) to the Left
Upright (89) in the same way. Note: There are
no wires on the left side.
Then, remove and discard the indicated screws
(E).
86
86
E
To Next Page
Loading...
