NordicTrack CTK6250 - How to Move the INCLINE TRAINER

9
HOW TO MOVE THE INCLINE TRAINER
Before moving the INCLINE TRAINER, adjust the
incline to 30% and then unplug the power cord.
Note: It may be necessary to disconnect the CATV
cable and the network wire from the INCLINE
TRAINER, depending on how far the INCLINE
TRAINER will be moved.
Due to the size and weight of the INCLINE
TRAINER, moving it requires two persons. While
one person lifts the indicated end, firmly hold the
handrails and tip the INCLINE TRAINER forward
until it rolls on the front wheels. Carefully move the
INCLINE TRAINER to the desired location and then
lower it back to the level position. CAUTION: To re-
duce the risk of injury, use extreme caution while
moving the INCLINE TRAINER. Do not attempt to
move the INCLINE TRAINER over uneven surfaces.
Lift
Here
Wheels
Tip
Handrails
Back
9. Make sure that all parts are properly tightened before you use the INCLINE TRAINER. Keep the included
allen wrenches for adjustment purposes. To protect the floor or carpet from damage, place a mat under the
INCLINE TRAINER.
8. After the INCLINE TRAINER is placed in the location
where it will be used (refer to HOW TO MOVE THE IN-
CLINE TRAINER below), make sure that both Rear
Feet (66) and both Wheels (not shown) rest firmly on
the floor. If the INCLINE TRAINER rocks even slightly,
turn the right Rear Foot clockwise or counterclockwise
until the rocking motion is eliminated.
66
8