11
11
55
53
18
5
4
12
11. While a second person holds the Handlebar (5)
near the Upright (4), locate the Pulse Wires (55)
inside the Handlebar and route them through the
Upright as shown.
Tip: Avoid pinching the Pulse Wires (55).
Attach the Handlebar (5) to the Upright (4) with
four M8 x 16mm Screws (53) and four M8 Split
Washers (18); start all the Screws, and then
tighten them.
Avoid pinching the
Pulse Wires (55)
51
35
85
4
12. Press the Front and Rear Upright Covers
(51, 85) together around the Upright (4). Then,
attach them with two M4 x 18mm Screws (35).
To Next Page
Loading...
