12
13
14. Identify the Right Arm Front and Rear Covers
(42, 102), and orient them as shown.
Press the Right Arm Front and Rear Covers
(42, 102) together around the right Upper Body
Leg (7). Then, attach them with two M3 x 10mm
Screws (41).
Attach the Left Arm Rear and Front Covers
(88, 103) to the left Upper Body Leg (7) in the
same way.
41
102
103
42
88
7
7
14
47
106
52
52
55
50
13. While a second person holds the Console (47)
near the Upright (4), plug the Upper Wire (50)
and the Pulse Wires (55) into the receptacles on
the Console.
The connectors on the Upper Wire (50) and
the Pulse Wires (55) should slide easily into
the receptacles and snap into place. If a
connector does not slide easily into a receptacle,
turn the connector and try again. If you do not
connect the connectors properly, the Console
(47) may become damaged when you use the
elliptical.
Insert the excess wires into the Upright (4).
Tip: Avoid pinching the wires. Attach the
Console (47) to the Upright (4) with four
M4 x 10mm Screws (52) and four M4 Washers
(106); start all the Screws, and then tighten
them.
Avoid pinching
the wires
106
4
To Next Page
Loading...
