CLOSING AND OPENING THE WEIGHT SYSTEM
To close the weight system, first remove all acces-
sories from the Cable Stops (37). Store the acces-
sories if desired (see STORING THE ACCESSORIES
on page 7). Then, adjust the Pulley Carriages (20) to
the highest position (see ADJUSTING THE PULLEY
CARRIAGES above).
Next, unlock the Right Wheel (79) by lifting upward on
the right wheel lock. Then, locate the words 1st FOLD
on the Right Top Frame (6). Pull the Adjustment Knob
(29) that is below the words 1st FOLD. Rotate the
Right Frame (2) towards the Center Shroud (17).
Lock the Right Wheel by pressing downward on the
right wheel lock.
Unlock the Left Wheel (47) by lifting upward on the
left wheel lock. Next, locate the words 2nd FOLD on
the Left Top Frame (7). Pull the Adjustment Knob (29)
that is below the words 2nd FOLD. Then, rotate the
Left Frame (3) towards the Center Shroud (17) until
the Magnets (36) engage the Right Frame (2). Lock
the Left Wheel by pressing downward on the left
wheel lock.
To open the weight system, lift upward on the left
wheel lock to unlock the Left Wheel (47). Rotate the
Left Frame (3) away from the Center Shroud (17) until
the Adjustment Knob (29) engages the hole in the
Left Top Frame (7). Press downward on the left wheel
lock to lock the Left Wheel. Open the Right Frame
(2) in the same way.
29
6
29
17
47
1st Fold
2nd Fold
Wheel
Lock
Wheel
Lock
79
3
7
36
36
2
8
ADJUSTING THE PULLEY CARRIAGES
To adjust the height of the right Pulley Carriage (20),
pull the indicated Adjustment Knob (29), slide the
r
ight Pulley Carriage to the desired height, and then
engage the Adjustment Knob in one of the adjustment
holes in the Right Pulley Carriage Guide (90). Make
sure that the Adjustment Knob is fully engaged in
o
ne of the holes in the Right Pulley Carriage
Guide.
Adjust the left Pulley Carriage (not shown) in the
same way.
29
20
20
9
0
37
To Next Page
Loading...
