NordicTrack E8200 Competition Bench - Weight Carriage and Spotter Assembly Steps

11
15. Insert a screwdriver (not included) into the indicat-
ed hole in one of the Weight Carriage Tubes (8).
Use the screwdriver to firmly tighten the Weight
C
arriage Tube onto the Weight Carriage (7).
A
ttach the other Weight Carriage Tube (8) in
the same way.
Next, slide two Weight Adapters (156) onto the
Weight Carriage Tubes (8). Tighten two M8 x
10mm Set Screws (157) against the Weight
Carriage Tubes.
16. Engage each Spotter Hook (24) into an adjust-
ment slot near the bottom of the Left and Right
Uprights (1, 2). Always position both Weight
Bar Spotters (23) at the same height.
8
7
Hole
156
157
157
156
8
15
24
24
1
2
23
16
17. Orient the Locking Bar (19) as shown. Have a
second person hold the Locking Bar between the
left Weight Bar Carriage (20) and the right Weight
Bar Carriage (not shown).
Insert the Weight Bar (18) into the left Weight Bar
Carriage (20), the Locking Bar (19), and the right
Weight Bar Carriage (not shown). Center the
Weight Bar. Then, engage the Locking Bar into
slots in the Left and Right Uprights (1, 2).
19
20
18
1
2
23
17