NordicTrack E8200 Competition Bench - Weight Bar Adapters and Cable Routing Steps

12
19. Remove the Lower Cable Eyelet (10), the M8 Nut
(99), and the Cable Stop (103) from the Low
Cable (52). Route the Cable through the Foot
Plate (28).
Attach the Foot Plate (28) to the Center Upright
(3) with two M12 x 70mm Patch Bolts (89) and
two M12 Washers (93).
Slide the Cable Stop (103) onto the Low Cable
(52), and tighten the M8 Nut (99) onto the Cable
as far as possible. Next, tighten the Lower Cable
Eyelet (10) onto the Cable as far as possible, and
tighten the Nut against the Lower Cable Eyelet.
Then, slide the Cable Stop onto the Lower Cable
Eyelet.
20. Orient a Barbell Rest (30) as shown, and insert
the pin on the Barbell Rest into a slot in the Right
Upright (2). Then, rotate the Barbell Rest to the
position shown in the inset drawing and slide it
downward as far as possible.
Attach a Barbell Spotter (29) below the Barbell
Rest (30) in the same way.
Then, attach the other Barbell Rest (30) and the
other Barbell Spotter (29) to the Left Upright (1).
99
52
28
10
103
89
93
93
89
3
1
2
30
30
Pin
29
29
20
18. Slide a Weight Bar Adapter (22) onto the Weight
Bar (18). Then, tighten a Weight Bar End Knob
(44) into the Weight Bar.
Attach the other Weight Bar Adapter (not
s
hown) in the same way.
18
22
44
18
30
19