NordicTrack E8200 Competition Bench - Part Identification Chart

5
Refer to the drawings below to identify small parts used in assembly. The number in parentheses by each draw-
i
ng is the key number of the part, from the PART LIST near the end of this manual. Note: Some small parts
may have been preattached. If a part is not in the hardware kit, check to see if it has been preattached.
PART IDENTIFICATION CHART
M8 Locknut (84)
M6 Washer (61)
M8 Washer (102)
M4 Washer (98)
M12 x 75mm Bolt (88)
M4 x 15mm
Self-tapping Screw (95)
M8 x 45mm Bolt (101)
M10 x 183mm Bolt (83)
M12 x 70mm Patch Bolt (89)
M8 x 75mm Carriage Bolt (121)
M12 x 63mm Patch Bolt (90)
M12 x 20mm
Patch Bolt (91)
M10 Washer (66)
M12 Washer (93)
M6 x 40mm Screw (80)
M6 x 20mm
Screw (100)
M10 x 75mm Bolt (105)
M10 x 70mm Bolt Set (106)
Set Screw (157)
M10 Locknut (65)