7
3. Attach the Front Leg (109) to the Bench Frame
(107) with two M10 x 75mm Bolts (105), two M10
Washers (66), and two M10 Locknuts (65). Make
s
ure that the Locknuts are in the hexagonal
holes in the bottom of the Bench Frame.
See step 2. Tighten the M8 Locknuts (84).
4. Grease the barrel of an M10 x 70mm Bolt Set
(106). Attach the Leg Lever (110) to the Front Leg
(109) with the Bolt Set. Make sure that the bar-
rel of the Bolt Set is inserted through both
sides of the bracket on the Leg Lever.
Next, slide a Weight Adapter (156) onto the Leg
Lever (110). Then, tighten an M8 x 10mm Set
Screw (157) against the Leg Lever.
5. Orient the two Backrest Frames (118) as shown.
Attach the Backrest Frames to the Backrest
Bracket (111) with four M8 x 45mm Bolts (101),
four M8 Washers (102), and four M8 Locknuts
(84). Do not tighten the Locknuts yet.
109
65
66
105
1
07
3
110
106
106
Grease
109
156
157
4
101
118
102
Holes
102
101
84
84
111
5
To Next Page
Loading...
