Rfthe speed or incline setting for the current seg-
ment is too high or too low, you can override the
setting by pressing the Speed or Rnclinebuttons;
however, when the console compares your heart
rate to the current target heart rate setting, the
speed or incline of the treadmill may automatically
change.
To stop the program at any time, press the Stop
button. To restart the program, press the Start but-
ton. The walking belt will begin to move at 1 mph.
When the console compares your heart rate to the
current target heart rate setting, the speed or in-
cline of the treadmill may automatically change.
RfPulse program 1 is selected, the program will
continue until you stop it by pressing the Stop but-
ton. RfPulse program 2, 3, or 4 is selected, the
program will continue until the small arrow
reaches the right end of the profile. The walking
belt will then slow to a stop.
Turn on the fan if desired.
See step 8 on page 16.
When you are finished exercising, remove the
key from the console.
See step 8 on page 18.
22
To Next Page
Loading...
