HOW TO FOLD AND MOVE THE TREADMmLL
HOW TO FOLD THE TREADMILL FOR STORAGE
Before fo_ding the treadmill, adjust the incline to the
_owest position, ff this is not done, the treadmill may be
permanently damaged. Next, unplug the power cord.
CAUTION: You must be able to safe_y _ift 45 pounds (20
kg) to raise, _ower, or move the treadmill.
1. Hold the end of the treadmill near the location indicated by
the arrow at the right. To decrease the possibility of in-
jury, bend your _egs and keep your back straight. As
you raise the frame, make sure to lift with your _egs
rather than your back. Raise the frame about halfway to
the vertical position.
2. Move your right hand to the position shown and hold the
treadmill firmly. Using your left hand, pull the latch knob
to the left and hold it. Raise the treadmill until the catch is
aligned with the latch pin. Slowly release the latch knob.
Make sure that the _atch pin is fully inserted into the
catch.
To protect the floor or carpet from damage, p_ace a
mat under the treadmill. Keep the treadmill out of
direct sunlight. Do not meavethe treadmill in the stor-
age position in temperatures above 85° Fahrenheit..
Latch
HOW TO MOVE THE TREADMILL
Before moving the treadmill, convert the treadmill to the
storage position as described above. Make sure that the
_atch pin is fully inserted into the catch.
1. Hold the treadmill and place one foot against one of the
wheels.
2. Tilt the treadmill back until it roils on the wheels. Carefully
move the treadmill to the desired location. To reduce the
risk of injury, use e×treme caution whi_e moving the
treadmill. Do not attempt to move the treadmill over
an uneven surface.
3. Place one foot against one of the wheels, and carefully
lower the treadmill until the base is in the storage position.
Whee
Base
25
To Next Page
Loading...
