Assemblyrequirestwopersons.Setthetreadmillinaclearedareaandremoveallpackingmaterials.Donot
disposeofthepackingmaterialsuntilassemblyiscompleted.Note:Theundersideofthetreadmillwalkingbeltis
coatedwithNgh_performancelubricant.Duringshipping,asmallamountoflubricantmaybetransferredto the
topofthewalkingbeltorthesNppingcarton.Thisisanormalconditionanddoesnotaffecttreadmillperfor-
mance.Ifthereislubricantontopofthewalkingbelt,simplywipeoffthelubricantwitha softclothandamild,
non-abrasivecleaner.
[
Assembly requires the included allen wrench _ and your own phillips screwdriver
For help identifying assembly hardware, see the drawings below. Note: If a part is not found in the part bags,
check to see if the part has been preattached. To avoid damaging p_astic parts, do not use power too_s for
assembly.
Upright Star Handrail Star
Washer (71)-6 Washer (90)-6
Washer (78)-6
Handrail Bolt (64)-6
Upright Bolt (72)-6
1. Identify the Left and Right Uprights (73, 74). The Left
Upright has two large holes in the indicated locations.
Set the Right Upright (74) near the Frame (48) as
shown. Insert the Upright Wire Harness (75) into the
lower end of the Right Upright and out of the top.
Place an elastic band around the Upright Wire Harness
(75) and the Right Upright (74) to keep the Upright Wire
Harness from falling into the Right Upright. Leave the
elastic band on until step 6.
48
Large Hole
Band
74
Small
Holes
73
Large Hole
To Next Page
Loading...
