12
22. Wrap the Butterfly Cable (73) around a ÒVÓ-Pulley
(27) in the direction shown. Attach the ÒVÓ-Pulley and
a Large Cable Trap (32) to the welded bracket (not
visible in the drawing) on the back of the Butterfly
Upright (1) with a 3/8Ó x 2 1/2Ó Bolt (53) and a 3/8Ó
Nylon Locknut (50). Make sure that the Large Cable
Trap is oriented as shown.
22
50
53
27
32
1
73
Bracket
23. Attach the Butterfly Cable (73) to the welded bracket
on the Right Butterfly Arm (10) with a 3/8Ó x 1Ó Bolt
(84) and two 3/8Ó Nylon Jam Nuts (63). Note: The
loop on the Cable and the two Nylon Jam Nuts
must be mounted underneath the welded bracket.
23
73
10
63
84
21. Remove both 3 1/2Ó Pulleys (24) and Cable Traps
(25) from the pre-assembled Adjustable Pulley Plates
(23).
Wrap the Butterfly Cable (73) around a 3 1/2Ó Pulley
(24) in the direction shown. Attach the Pulley to the
top hole in the Adjustable Pulley Plates (23) with a
3/8Ó x 2Ó Bolt (54) and a 3/8Ó Nylon Locknut (50).
Make sure the Cable Trap and the Adjustable
Pulley Plates are oriented as shown in the draw-
ing.
21
25
54
23
24
23
20. Wrap the Butterfly Cable (73) around a ÒVÓ-Pulley
(27) in the direction shown. Attach the ÒVÓ-Pulley and
a Large Cable Trap (32) to the welded bracket on the
back of the Butterfly Upright (1) with a 3/8Ó x 2 1/2Ó
Bolt (53) and a 3/8Ó Nylon Locknut (50). Make sure
that the Large Cable Trap is turned as shown.
20
53
73
27
50
1
32
50
73
Welded
Bracket
Welded Bracket
To Next Page
Loading...
