14
27. Remove both 3 1/2Ó Pulleys (24) from the pre-assem-
bled Pulley Frame (22).
Wrap the Weight Cable (72) around a 3 1/2Ó Pulley
(24) in the direction shown. Attach the 3 1/2Ó Pulley to
the Pulley Frame (22) with a 3/8Ó x 1 3/4Ó Bolt (57)
and a 3/8Ó Nylon Locknut (50). Make sure that the
Pulley Frame is turned as shown.
26. Place the Weight Cable (72) in the groove of a
3 1/2Ó Pulley (24) and push the Pulley up into the
welded bracket on the Weight Upright (9). Attach the
3 1/2Ó Pulley inside the welded bracket on the Weight
Upright (9) with a 3/8Ó x 1 3/4Ó Bolt (57) and a
3/8Ó Nylon Locknut (50).
26
50
9
50
24
57
22
72
57
24
72
Welded
Bracket
27
28. Attach the closed loop on the Weight Cable (72)
inside the indicated slot in the Weight Upright (9) with
a 3/8Ó x 2 3/4Ó Bolt (46), two 3/8Ó Flat Washers (48),
and a 3/8Ó Nylon Locknut (50).
48
46
72
50
48
9
28
Slot
To Next Page
Loading...
