NordicTrack Grt470 - Welded

22
52. Insert a 1/4Ó x 2 1/2Ó Carriage Bolt (45) into the center
hole in a Seat Plate (65). Attach the Seat Plate to a
Seat (13) with two 1/4Ó x 3/4Ó Bolts (49). Insert the
1/4Ó x 2 1/2Ó Carriage Bolt (45) into the indicated hole
in the Press Seat Frame (7) and secure it with a 1/4Ó
Flat Washer (71) and a 1/4Ó Nylon Locknut (68).
Secure the other end of the Seat (13) with a
1/4Ó x 2 1/2Ó Bolt (79) and a 1/4Ó Flat Washer (71).
52
7
68
49
71
79
13
65
45
54. Remove the three preassembled 1/4Ó x 5/8Ó Screws
(95) from the Shroud (34). Attach the Shroud to the
indicated bracket on the Weight Base (5) with two
1/4Ó x 5/8Ó Screws.
54
5
34
95
55. Attach the Shroud (34) to the top of the Weight
Upright (9) with a 1/4Ó x 5/8Ó Screw (95).
55
95
9
34
53. Attach the Curl Pad (91) to the welded plate on the
Butterfly Front Leg (3) with two 1/4Ó x 3/4Ó Bolts (49).
53
49
91
3