NordicTrack GRT500 - Backrest Position Adjustment; Pad Tube and Foam Pad Installation on Leg Lever and Base; Curl Pad and Curl Post Assembly

14
27. Press 3/4Ó Round Inner Caps (34) into the ends of the
two Pad Tubes (28).
Slide one Pad Tube (28) into the hole in the front leg
on the Base (8). Slide a Foam Pad (30) onto each
end of the Pad Tube.
Slide the other Pad Tube (28) into the hole in the Leg
Lever (29). Slide a Foam Pad (30) onto each end of
the Pad Tube.
27
34
8
29
34
30
28
34
30
30
34
26. Locate the Adjustment Knob (9) on the backrest tube
of the Main Upright (3). Turn the Knob counterclock-
wise to loosen it. Pull out the Knob as far as possible
and slide the Backrest Frame (15) into the backrest
tube.
Release the Adjustment Knob (9) and let the Knob
snap into one of the adjustment holes on the Backrest
Frame (15). Tighten the Knob fully.
26
3
9
15
Adjustment
Holes
Backrest
Tube
28. Attach the Curl Pad (82) to the Curl Post (83) with
four 1/4Ó x 3/4Ó Bolts (17).
Slide the Curl Post (83) onto the front leg on the Base
(8) and secure it with the Curl Knob (89).
83
8
17
89
82
28