NordicTrack GRT500 - High Cable Routing Through Press Frame and Uprights; High Cable Routing Between Press Frame and Upright

10. Wrap the High Cable (73) around a 4Ó Pulley (35) in
the direction shown. Attach the Pulley to the Press
Frame (12) with a 3/8Ó x 8 1/2Ó Bolt (59) and a 3/8Ó
Nylon Locknut (50).
Feed the bolt on the High Cable (73) back through
the slot in the Main Upright (3) in the direction shown.
9
10
9
Bolt
Slot
35
73
55
50
59
73
42
55
59
50
3
12
35
12
Slot
Bolt
42
54
35
9. Feed the bolt on the High Cable (73) under the wlded
tube on the Press Frame (12) as shown. Wrap the
High Cable around a 4Ó Pulley (35) in the direction
shown. Attach the Pulley to the Press Frame (12) with
a 3/8Ó x 8 1/2Ó Bolt (59) and a 3/8Ó Nylon Locknut (50).
Wrap the High Cable (73) around another 4Ó Pulley
(35). Attach the Pulley inside the indicated slot in the
Main Upright (3) with a 3/8Ó x 2 1/2Ó Bolt (54), two
3/8Ó Flat Washers (55), two 5/8Ó x 1/2Ó Pulley
Bushings (42), and a 3/8Ó Nylon Jamnut (63).
11. Wrap the High Cable (73) around a 4Ó Pulley (35).
Attach the Pulley inside the slot in the Main Upright
(3) with a 3/8Ó x 2 1/2Ó Bolt (54), two 3/8Ó Flat
Washers (55), two 5/8Ó x 1/2Ó Pulley Bushings (42),
and a 3/8Ó Nylon Jamnut (63).
11
55
42
63
3
35
42
55
54
73
63