11
8
9
24
26
37, 58
17
25
G
3
27
4
9. Orient the Console Cover (3) as shown, and
slide it onto the Upright (27).
Tip: Avoid pinching the Main Wire Harness
(25). Insert the Pivot Bracket (11) on the
Handlebar (4) into the Upright (27).
Attach the Pivot Bracket (11) with two
M8 x 58mm Bolts (24) and two M8 Locknuts
(17). Make sure that the Locknuts are in the
hexagonal holes (G).
Tip: If necessary, rotate the Handlebar (4) to a
different angle so that there is sufficient space to
tighten the M8 x 58mm Bolts (24).
8. Orient the Shield Cover (26) as shown, and
press it onto the Left and Right Shields (37, 58).
Avoid pinching
the Main Wire
Harness (25)
11
To Next Page
Loading...
