NordicTrack Gx5.1 Bike - Assembly Instructions

5
Assembly requires two persons. Place all parts of the exercise bike in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires an adjustable wrench and a Phillips
screwdriver .
Note: If a part is not in the hardware kit, check to see if it has been preattached.
1. Remove the two screws, the two washers, and
the shipping bracket (not shown) from the rear of
the Frame (1) if necessary. Discard the screws,
washers, and shipping bracket.
Identify the Rear Stabilizer (58), which does not
have wheels.
Attach the Rear Stabilizer (58) to the Frame (1)
with two M8 x 16mm Screws (55) and two M8
Washers (54).
1
55
54
58
1
2. Remove the two screws, the two washers,
and the shipping bracket (not shown) from the
front of the Frame (1) if necessary. Discard the
screws, washers, and shipping bracket.
Attach the Front Stabilizer (49) to the Frame (1)
with two M8 x 16mm Screws (55) and two M8
Washers (54).
2
49
55
54
1
ASSEMBLY