NordicTrack Incline Trainer X11 - Page 10

10
7. Set the Right Handrail Assembly (93) on the
right Upright (77). Make sure that no wires are
pinched.
Attach the Right Handrail Assembly (93) with
two 3/8" x 5 1/2" Screws (5) and two 3/8" Star
Washers (8). Note: Start the lower Screw first.
Then, connect the two “R” pulse wires.
L
R
R
7
5
“L” Pulse
Wire
Start First
93
77
8
“R”
Pulse
Wires
Console
Assembly
6. Tighten two #8 x 3/4" Screws (1) into the
Console Base (87). Do not overtighten the
Screws.
Identify the Right Handrail Assembly (93). Hold
the Right Handrail Assembly near the right
Upright (77). Insert the pulse wire from the Right
Handrail Assembly into the hole in the top of the
Upright and pull it out of the end of the Upright.
6
93
Pulse
Wire
1
1
87
77