NordicTrack Incline Trainer X11 - Page 8

8
2. Attach the Upright (77) to the Base (80) with
two 3/8" x 5 1/2" Screws (5) and a 3/8" x 2 3/4"
Screw (17) with three 3/8" Star Washers (8)
as shown. Start all three Screws, and then
tighten them. Make sure not to pinch the
Upright Wire (not shown) in the Upright.
Attach the other Upright (not shown) as
described above. Note: There is not a wire on
the left side.
2
77
17
80
8
8
5
3
89
37
A
A
3. Set the Console (37) face down on a soft surface
to avoid scraching the Console. Remove and
discard the four screws (A) from the Console
Base Back (89). Lift off the Console Base Back.