7. 7
HaveasecondpersonholdtheConsole(84)
neartheYoke(88).ConnecttheUprightWire
(72),theLeftandRightPulseWires(70,71),
andtheConsoleGroundWire(89)tothewires
extendingfromtheConsole.Seetheinset
drawing.The connectors should slide to-
gether easily and snap into place, if they do
not, turn one connector and try again. IF THE
CONNECTORS ARE NOT CONNECTED
PROPERLY, THE CONSOLE MAY BE DAM-
AGED WHEN THE POWER IS TURNED ON.
Insert the excess wire into the Console (84).
Console Wire
84
.
Attach the Console (84) to the plate on the Yoke
(88) with four #8 x 3/4" Screws (1). Be careful
not to pinch any wires. Start all four Screws
before tightening any of them. Do not over-
tighten the Screws.
84
10
To Next Page
Loading...
