NordicTrack Incline Trainer X3 NTL15008.0 - Page 8

Withthehelpofasecondperson,carefullytip
theinclinetrainerdownsothattheBase(78)is
flatonthefloor.
AttachaWheel(77)toeachsideof theBase
(78)witha3/8"x 2 1/2"Bolt(4)anda3/8"Nut
(8)(onlyonesideshown).
78
.
Hold the Yoke Spacer (87) near the Upright
(74). Make sure that the curved side of the
Yoke Spacer is facing the Upright. insert the
Upright Wire (72) through the Yoke Spacer.
Orient the Yoke (88) as shown, insert the
Upright Wire (72) through the Yoke.
Attach the Yoke (88) and the Yoke Spacer (87)
to the Upright (74) with two 3/8" Star Washers
(9) and two 3/8" x 5" Bolts (7); do not fully
tighten the Bolts yet.
Remove the wire tie from the Upright Wire (72).
4
88
74
Curved
Side