NordicTrack Incline Trainer X3 - Page 7

7
1. Make sure that the power cord is unplugged.
With the help of a second person, tip the incline
t
rainer onto its left side. Have the second person
hold the incline trainer to prevent it from tipping.
Attach four Base Feet (80) and four Base Foot
Spacers (79) to the Base (78) with four #8 x 1"
Tek Screws (2). Be careful not to overtighten
the Tek Screws.
1
2
2
80
80
80
79
79
78
2. Hold the Upright (74) near the incline trainer,
with the brackets on the Upright oriented as
shown.
See the inset drawing. Tie the wire tie in the
Upright (74) around the end of the Upright Wire
(72). Then, pull the other end of the wire tie until
the Upright Wire is routed completely through
the Upright.
Attach the Upright (74) to the Base (78) with
four 3/8" x 3 1/2" Patch Bolts (3) and four 3/8"
Star Washers (9). Start all four Patch Bolts
before tightening any of them. Be careful not
to pinch the Upright Wire (72).
2
74
78
9
3
72
9
74
72
Wire
Tie
Bracket
3
79
80
2
79
2
Wire
Tie