10
5. Position the Console Crossbar (103) between
the Uprights (77, 79) as shown. Attach the
Console Crossbar to the Uprights with four 5/16"
x 2 3/4" Screws (4) and four 5/16" Star Washers
(9). Do not fully tighten the Screws yet.
Remove the wire tie from the Upright Wire (78).
5
103
4
9
77
79
78
Wire Tie
4
9
4
89
87
1
04
4. Set the Console Cover (87) face down on a soft
surface. Remove the two #8 x 1 1/2" Screws
(104) from the Console Back (89). Save the
S
crews for step 6. Separate the Console Back
from the Console Cover, and remove the
C
onsole Crossbar (not shown) from inside.
To Next Page
Loading...
