12
9. Attach the Console (85) with four #8 x 3/4"
Screws (1). Start all four Screws, and then
tighten each of them. Do not overtighten the
Screws.
Tighten the four loops around the wires by
pulling on the ends of the ties.
See step 5. Tighten the 5/16" x 2 3/4" Screws
(4).
9
1
1
85
Ties
Ties
8. Have a second person hold the Console (85)
near the Console Cover (87). Insert the wires
from the Console through the indicated hole.
Connect the Upright Wire (78), the Left and
R
ight Pulse Wires (90, 91), and the Ground
Wire (97) to the wires extending from the
Console (85). See the inset drawing. The con-
nectors should slide together easily and
snap into place. If they do not, turn one con-
nector and try again. IF YOU DO NOT CON-
NECT THE CONNECTORS PROPERLY, THE
CONSOLE MAY BECOME DAMAGED WHEN
YOU TURN ON THE POWER.
8
85
87
91
78
Hole
90
78
Console Wire
Wires
97
To Next Page
Loading...
