30
SYMPTOM: The walking belt is off-center or slips
when walked on
a
. If the walking belt is off-center, first remove the
key and UNPLUG THE POWER CORD. If the
w
alking belt has shifted to the left, use the hex
key to turn the left idler roller screw clockwise 1/2
of a turn; if the walking belt has shifted to the
right, turn the left idler roller screw counterclock-
wise 1/2 of a turn. Be careful not to overtighten the
walking belt. Then, plug in the power cord, insert
the key, and run the incline trainer for a few min-
utes. Repeat until the walking belt is centered.
b. If the walking belt slips when walked on, first re-
move the key and UNPLUG THE POWER CORD.
Using the hex key, turn both idler roller screws
clockwise, 1/4 of a turn. When the walking belt is
correctly tightened, you should be able to lift each
edge of the walking belt 3 to 4 in. (8 to 10 cm) off
the walking platform. Be careful to keep the walk-
ing belt centered. Then, plug in the power cord, in-
sert the key, and carefully walk on the incline
trainer for a few minutes. Repeat until the walking
belt is properly tightened.
SYMPTOM: The iFit Live mode does not function
correctly
a
. If the iFit Live mode is not functioning correctly,
make sure that the incline trainer has the most cur-
r
ent firmware available (see step 3 on page 24).
SYMPTOM: The buttons on the screen do not work
correctly
a. If the screen is not properly calibrated, it will be dif-
ficult to touch the correct buttons on the screen. To
calibrate the screen, see step 5 on page 24.
a
b
To Next Page
Loading...
