11
98
96
95
101
1
1
9
9. Identify the Left and Right Trays (95, 96).
Attach the Left and Right Trays (95, 96) to the
Console Base (98) with eight #8 x 1/2" Screws
(1). Tip: It may be easier to start the two
inside Screws and then slide the Trays into
place before tightening the other six Screws.
Note: It may be necessary to rotate the Console
Frame (101) upward when attaching the Left and
Right Trays (95, 96).
1
1
1
10. IMPORTANT: To avoid damaging the Pulse
Crossbar (81), do not use power tools and do
not overtighten the #10 x 3/4" Screws (4).
Orient the Pulse Crossbar (81) as shown. Attach
the Pulse Crossbar to the Handrails (79) with
four #10 x 3/4" Screws (4) and four #10 Star
Washers (5). Start all four Screws, and then
tighten them.
Make sure that the Upright Wire (91) is not
pinched. Firmly tighten the four 5/16" x 2 3/4"
Screws (12).
10
4
4
5
5
12
12
79
81
79
91
To Next Page
Loading...
