NordicTrack NETL17812.0 - Assembly

7
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materialsuntilyounishallassemblysteps.
• After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal. If
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
• Left parts are marked “L” or “Left and right parts
are marked “R” or “Right.”
• To identify small parts, see page 6.
• Assembly requires the following tools:
the included hex keys
one adjustable wrench
one Phillips screwdriver
scissors
needlenose pliers
To avoid damaging parts, do not use power tools.
ASSEMBLY
1. Make sure that the power cord is unplugged.
With the help of a second person, tip the tread-
mill onto its right side.
Pull the Upright Wire (91) and the base ground
wire (A) through the indicated hole in the
Base (29).
Attach the base ground wire (A) to the Base (29)
with a #8 x 1/2" Ground Screw (6).
Make sure that the Grommet (90) is pressed into
the square hole in the Base.
See the inset drawing. Cut the plastic tie near
the Upright Wire (91). Be careful not to dam-
age the Upright Wire.
Cut
91
Tie
2. Attach the Left Wheel Cap (113) to the Base (29)
with two #8 x 3/4" Screws (14).
Attach four Base Pads (37) to the Base (29) with
eight #8 x 3/4" Tek Screws (13) (only one side is
shown). Do not overtighten the Screws.
With the help of a second person, tip the tread-
mill so that the Base (29) is flat on the floor.
Attach the Right Wheel Cap (not shown) as
described above.
2
91
A
6
Hole
29
14
113
29
1
37
13
37
13
90