NordicTrack NETL29716.0 - 3;4 Screws (6); Start All Four Screws, and then

10
8. Set the console assembly (F) face down on a
soft surface to avoid scratching the console
assembly.
Remove and discard the four indicated screws
(G). Then, remove the Pulse Crossbar (80).
F
80
G
8
G
9. IMPORTANT: To avoid damaging the Pulse
Crossbar (80), do not use power tools, and do
not overtighten the #10 x 3/4" Screws (6) or
the 5/16" x 3" Screws (88).
Orient the Pulse Crossbar (80) as shown. Attach
the Pulse Crossbar with two of the 5/16" x 3"
Screws (88) and two of the 5/16" Star Washers
(8) that you removed in step 3, and two #10 x
3/4" Screws (6); start all four Screws, and then
tighten them.
Be careful not to pinch the Upright Wire (83)
or the fan wire (A). Position the wires in the
cutouts as shown.
Then, tighten the other two 5/16" x 3"
Screws (88).
80
9
8
8
88
88
88
88
6
6
A
83